Owner Responsibility; Product Description; Intended Use; Introduction - HTC D 10 Manual Del Usuario

Introduction................................................................... 15
Safety............................................................................19
Assembly...................................................................... 20
Operation...................................................................... 21

Owner responsibility

WARNING: Cutting, especially when DRY
cutting, generates dust that comes from the
material being cut, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
949 - 002 - 08.04.2019
Contents
Maintenance................................................................. 23
Troubleshooting............................................................ 24
Transportation, storage and disposal........................... 25
Technical data.............................................................. 25

Introduction

It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
• The products's safety instructions.
• The products's range of applications and limitations.
• How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.

Product description

The product is a single phase dust extractor. Dust-laden
air goes through the suction hose into the inlet valve.
The product separates the dust particles from the air.
The particles falls into the plastic bag at the bottom of
the product.

Intended use

The machine is designed for vacuuming and separating
dry, non-combustible dust with an explosion limit value
of >0.1mg/m
To minimize dust emissions, wet cut when
feasible. If dry cutting is necessary, use an
appropriate dust extractor.
3
. Do not use the product for other tasks.
15