Astralpool 75973 Manual De Instalación Y De Mantenimiento página 3

Idiomas disponibles

3. CONTENT OF THE PACKAGING:

• 1 UNIK level regulator. Includes: sensor, fixing screw, water inlet jet and cable gasket.

• 10 m of 2 x 0.25 mm cable.

• Instruction manual.

4. TOOLS REQUIRED:

5. INSTALLATION

• When installing the regulator, the inside of the skimmer should not contain water.

• Position the regulator (A) and the water inlet jet (B). See figure 1, page 46.

• Before fitting the skimmer in position, make the holes required for correct installation. See figure 2-3-4-5,

page 40.

• Fitting the sensor (A): See figure 6, page 40.

1. Loosen the nut (1), place the sensor inside the level regulator housing (2) and retighten the nut.

2. Place the gasket (3) in the 6.5 mm hole of the skimmer for the cable to pass through.

3. Insert the 10 m of cable through the cable gasket and into the corrugated pipe (installed previously),

making sure there is a length of 8 cm inside the regulator.

4. Position the regulator in the marked guides (4) and tighten the screw (5).

5. Regulate the required water level.

Note: See figure 7, page 47.

If a hole is made in the overflow at the back of the skimmer, the water level must be regulated to a few

centimeters below it.

• Fitting the water inlet jet (B): See figure 8, page 47.

1. Fit the jet (1) with the gasket (2) on the inside of the skimmer.

2. Tighten the nut (3) on the outside of the skimmer.

3. To fit the water inlet in position, glue the Ø20 pipe or thread to the G3/4 connection.

6. ELECTRICAL WIRING:

• Connect the sensor contact to a control device (not included) used to open the valve for filling the pool.

• The control device must have a safety system to prevent the filling valve from remaining open if the pool

or one of its components has a permanent water leak.

• The sensor contact closes when the water level drops to the set level. See figure 9, page 47.

• Maximum sensor contact voltage and current: 12VAC/30VDC 1A.

• The control device must be powered or it must contain a safety isolating transformer.

7. MAINTENANCE:

Remove the regulator on a regular basis to clean the inside.

6,5