Publicidad
Idiomas disponibles
Idiomas disponibles
SELECTING MAX 2h MODE
SETTING THE TIME
A flash every 2 seconds indicates a time disruption following a power cut.
This flash is reversed (light goes out briefly every 2 seconds) when the
LED is on during the heating cycle.
The time can only be set to certain hours: 12:00, 17:00 or 20:00.
1- Select frost protection mode.
2- Select programme P1 if it is 12:00, or programme P2 if it is 17:00, or
Programme P3 if it is 20:00.
3- Briefly disconnect the appliance from the mains supply.
4- Select the desired program and set the setpoint temperature.
Tip : the offset of the time setting offsets all of the programme times (for
example, setting the time to 13:00 instead of 12:00 delays the programme
times by 1 hour).
STORAGE
- Keep the original packaging to disassemble the appliance and store it.
- Keep the appliance in a dry and clean place.
- Store the unit out of reach of children.
- The MAX 2h boost button sets the temperature to
the maximum for 2 hours.
After 2 hours in boost mode, the Comfort temperature
setting is re-established.
9
Quick start
Publicidad
