LiftMaster LMWEKITU Manual Del Usuario página 3

INSTALL TRANSMITTER BATTERIES AND SET
2
EDGE DIRECTION
1. Open the transmitter housing.
2. Install the batteries. DO NOT let the bottom housing hang by the wires. Energizer
Ultimate Lithium AA L91 batteries are REQUIRED as replacements.
3. The Open/Close dip switch should be set to CLOSE for door applications.
OPEN/CLOSE DIP Switches
PROGRAMMING
3
1. Press the learn button on the RECEIVER board. The red LED will come on to
indicate programming mode. NOTE: To exit programming mode, press the learn
button again.
2. Press the learn button on the TRANSMITTER to be learned. The red LED on the
RECEIVER will blink 4 times. NOTE: Learn mode times out after 60 seconds.
Learn Button
MOUNT THE RECEIVER
4
IMPORTANT: Disconnect ALL power to the operator.
1. Attach the mounting bracket to the operator or wall with the screws provided (8-32
3/8" or 10-16 3/4").
2. Attach the receiver housing with screws provided.
3. Place the receiver onto the mounting bracket and secure with the 1/4" screw
provided.
4. Reconnect power to the operator.
1 2
OR
5
®
6
7
BATTERY STATUS
When the edge is activated, the red status LEDs on the transmitter(s) and receiver flash to indicate
the battery status.
NOTE: The receiver LED corresponds to the lowest battery level of all transmitters.
1 Flash
2 Flashes
3 Flashes
3
3
WIRE AND MOUNT THE TRANSMITTER(S)
For best results, install with a clear line of sight between transmitter and operator.
1. Route the wires from the edge sensor into the transmitter. Connect the wires to either
terminal block (polarity is NOT important). The operator will beep once to indicate the
edge sensor has been learned. Apply pressure to edge. The red LED will flash if the
transmitter is wired correctly. Tighten the Heyco connector with 25 in. lbs. of torque
to make transmitter watertight. Use double hole Heyco connector when connecting 2
edge sensors (for gate operations only).
2. Attach the mounting bracket to the door with the screws provided (8-32 3/8" or 10-16
3/4") at least 3.28 ft. (1 m) above the ground. If installing on a round surface, use zip
ties (not provided).
3. Attach the transmitter housing with the screws provided.
4. Place the transmitter onto the mounting bracket and secure with the
1/4" screw provided.
TEST
Apply pressure to edge. The red LED on the TRANSMITTER will flash. The controller
LCD should state WLESS BLOCKED. If the TRANSMITTER LED does not flash, check
the transmitter for proper installation and wiring. See the Transmitter and Receiver
Troubleshooting page and check the edge sensor for proper installation and wiring.
TO UNLEARN DEVICE
To unlearn devices, press and hold the learn button on the RECEIVER. Continue to hold
the learn button while the red LED flashes. Once the LED stops flashing device reset is
complete and you can release the learn button.
Battery is fine.
Battery is low; the operator will beep twice.
Battery is critically low; the operator will not function until the battery is
replaced. The operator will either open automatically (fail-safe) or latch
at close (fail-secure) based on the operator setting (see the operator's
manual for more information).
Status LED