ENGLISH
assembly, just make sure you read the
operating instructions before plugging it
in.
USING THE APPLIANCE
This device is easy to use and does not
require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
(
Control panel
see picture 02 on page 4)
13. Cold button: press this button to
activate the cold air mode. You must
insert the ice blocks.
14.
OFF button: press the button to
turn off the fan mode.
15. Low speed button: press it to run the
product at low speed.
16. Medium speed button: press it to run
the product at medium speed.
17. High speed button: press to operate
the product at high speed.
18. Oscillation button: press the button to
make the flaps move from left to right.
The horizontal blades need to be manually
adjusted, unlike the vertical blades that
work automatically.
How to refill the water tank
Follow these steps (see picture 03 on page
5):
• Turn the water tank lock (A).
• Remove the water tank (B) from the
back and bottom.
• Fill the tank with clean water (water
temperature must not be higher than
40°C).
• Please check the water level while
pouring water.
• The water level in the tank must be
below the "max" line when you are
pouring water.
• The water level in the tank must be
above the "min" line when the cooling
and humidifying functions of the air
conditioner are on.
• Make sure that the outside of the unit
is not wet or damp. If not, dry it with a
22
cloth.
Note: If you are going to use cold
accumulators, we recommend that you
insert them before filling the tank so
as not to exceed the maximum level.
Alternatively, if they are to be inserted after
filling, leave the water level below "MAX".
Ice packs
When the outside temperature is high and
ice blocks are used, condensed water may
appear in the water tank and drip onto the
floor.
• Put the ice packs into a freezer for at
least 4 hours before use.
• Put the ice packs into the water tank
before filling water into the tank.
Inappropriate use
• Do not place the appliance on a wet or
flooded surface
• Do not put any objects on the appliance.
Do not block the air inlets and outlets.
• This appliance must not be used in the
open air.
• The
appliance
enlarged or remodelled
• You may only use the appliance as
indicated in this manual, otherwise the
warranty will be void and any liability
will be extinguished.
CLEANING AND MAINTENANCE
To avoid accidents caused by
electric shock, make sure that
no power is supplied to the unit
before starting maintenance or
repair.
Air filter cleaning
If the air filter is blocked by the
accumulation of a large amount of dust,
the volume of the air flow will be reduced.
Clean the filter once every two weeks.
Note: do not use the appliance without the
filters. Do not use it either if the filters are
cannot
be
altered,