Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
Remove the bolt,"R" lock pin and 2 set screws from the downrod and then take down the hanger ball.
Feed the motor wire plug up through the inside of the downrod,then �ghten the 2 set screws for hanger ball firmly.
3
Bolt
coupling
Insert the downrod into the coupling.
Gently push the bolt through the holes alighed with the base of the coupling and downrod.
Insert "R" lock pin into bolt and secure downrod with 2 set screws.
CAUTION: DO NOT force the bolt.Gently wiggle and rotate it un�l glides through both holes.
A�ach 5 blades to 5 blade brackets using blade screws and washers provided. Tighten screws securely.
Install 5 blade brackets assembly to motor using the pre-installed screws. Tighten screws securely.
4
Remove 3 screws from the light kit, and then connect 2 connectors.
Install the light kit to the motor with 3 screws.
Warning:Failure to disconnect power supply prior to installa�on may result in serious injury.
For safety and best opera�ng results,recommend you have a qualified electrician install this fan.
Secure moun�ng bracket to outlet box by �ghtening moun�ng screws & washers.
The ceiling fan must be installed in a loca�on with a minimum of 300mm spacing from the �p of
the blade to the nearest objects or walls.Secure the moun�ng bracket to the ceiling joist or
structure that is capable of carrying a load of at least 15.9kgs,with two long screws provided.
Ensure at least 30mm of the screws is threaded into the support.
Note:For ease of wiring feed house wires through moun�ng bracket.
Moun�ng screws
X2
"R" lock pin
X15
X15
2 set screws
X5
Installation & Operating Instructions for the
Parrot uncle Owner's Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
X5
F6367110V
x2
X10
X5
Publicidad
