ARDES ARSPRE03W Folleto De Instrucciones página 7

In case of failure, disconnect it at once. Do not attempt to repair it, but take it to a service centre approved by
the manufacturer.
If you decide you do not want to use this appliance any longer, disable it by cutting the power cable of course,
after disconnecting it from the socket.
In case of a breakdown or malfunctioning of the appliance, disconnect it at once. Do not attempt to repair it, but
take it to a service centre approved by the manufacturer.
The appliance was created and designed for use in domestic environments as indicated in the instructions. Any
other use is therefore considered improper and thus dangerous.
Do not use the appliance out of doors.
For safety reasons, the appliance should never be opened.
During use, rest the appliance on a flat surface.
To prevent children from accidentally touching hot components, use the appliance on surfaces that are at least
85 cm high.
Leave space around all other surfaces of the appliance and do not cover with other objects.
Do not place the cord and the appliance near sources of heat.
Do not place the appliance above or below other appliances, ovens, microwave ovens or close to gas stoves.
WARNING: Do not use this appliance near bathtubs, showers, sinks or other vessels that contain water.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
Use only the accessories supplied with the appliance.
(see the image on page 2)
A - Motor body
B – Juice conveyor
C – Filter
D – Small squeezing cone
E – Big squeezing cone
Contact with food
Only these parts are intended for contact with food, under the conditions indicated:
Parts intended for contact
with food
Juice conveyor (B)
Filter (C)
Small squeezing cone (D)
Big squeezing cone (E)
Squeezing Lid (F)
Non-drip spout (H)
- These parts can only be used with this appliance. Do not use the parts separately for other applications.
First use.
Before using the appliance for the first time, wash the parts in contact with food as indicated in the MAINTENANCE
paragraph.
Use of the appliance.
Assemble the accessories (see the image on page 2: fig. 1-2-3-4).
Place a suitable container in correspondence with the non-drip spout (H).
Open the non-drip spout (H) by placing it downwards.
Cut the citrus fruit to be squeezed in half.
Connect to the power supply.
Place the internal part of the fruit on the cone and lower the squeezing lid (F) using the lever (G); the motor will
start up the cone will begin to rotate and the juice will be collected in the container. Stopping pressing will also
stop the motor.
Note:
- Do not press too hard.
- Do not leave the motor running for more than 15 consecutive seconds; wait about 15 seconds
before starting it up again.
- After 5 minutes of use, let the appliance cool down for at least 30 minutes before using it again.
- To avoid leakage of juice, do not overfill the container.
Before removing the container, close the non-drip spout (H) by placing it upwards.
Disconnect the appliance from the power supply after use.
Clean the parts immediately (see MAINTENANCE) to avoid cleaning becoming difficult.
TECHNICAL INFORMATION
F – Squeezing Lid
G - Lever
H - Non-drip spout
Technical data: see the label on the appliance.
USER INSTRUCTIONS
Types of food
Citrus, citrus juice
Maximum temperature
40°C
Maximum time of
contact
30 min
7