Setting Up The System; Fixture Addressing; Manual Mode - Ibiza Light LC192DMX-MINI Manual De Instrucciones

Fixture refers to your lighting instrument or other device such as a fogger or dimmer which you can control.
Programs are a bunch of scenes stacked one after the other. They can be programmed as either a single scene or multiple scenes in
sequence.
Scenes are static snapshots of current channel values
Faders are slider adjustment controls for various parameters
Chases can also be called programs. A chase consists of a bunch of scenes stacked one after the other.
Scanner refers to a lighting instrument with a pan and tilt mirror; however, in the controller it can be used to control any DMX-512
compatible device as a generic fixture.
Stand Alone refers to a fixture's ability to function independently of an external controller and usually in sync to music, from a built-in
microphone.
Shutter is a mechanical device in the lighting fixture that allows you to block the lights path. It is often used to lessen the intensity of
the light output and to strobe.
Operating instructions
Setup
3.1
3.1.1

Setting up the system

Plug the AC to DC power supply to the back panel of the unit and to the mains outlet.
Plug in your DMX cable(s) to your intelligent light units as described in the fixtures' user manuals. For a quick introduction on DMX
see the "Introduction to DMX" section in the Appendix of this manual.
3.1.2

Fixture addressing

The FIXTURE is programmed to control 16 DMX channels per fixture, therefore the fixtures you wish to control via the
corresponding FIXTURE buttons on the unit, must be spaced 16 channels apart.
Fixture Default DMX Start Address
1
2
3
4
5
6
7
8
9
10
11
12
Please refer to your individual fixture's manual for DMX addressing instructions. The table above refers to a standard 9 dipswitch binary
configurable device.
3.1.3 Fade Time Assign
You can choose whether the unit's fade time during scene execution is implemented broadly to all output channels or only to the Pan &
Tilt movement channels. This is relevant because often you will want gobos and colors to change quickly while not affecting the
movement of the light.
Action:
1. Turn the FIXTURE power OFF
2. Hold the MODE and TAP DISPLAY buttons simultaneously and switch the power back ON
3. The FIXTURE is now in Fade Time Assign mode
4. Pres the TAP DISPLAY button to toggle between "ALL CH" and "ONLY X/Y"
5. ALL CH means that fade time affects all channels
6. ONLY X/Y means that fade time only affects pan and tilt functions
Operation
3.2
3.2.1

Manual Mode

The manual mode allows direct control of all fixtures. You are able to move them and change attributes by using the channel faders.
©Copyright LOTRONIC 2018
Binary DIP Switches Set to "ON"
1
17
33
49
65
81
97
113
129
145
161
177
1
1, 5
1, 6
1, 5, 6
1, 7
1, 5, 7
1, 6, 7
1, 5, 6, 7
1, 8
1, 5, 8
1, 6, 8
1, 5, 6, 8
LC192DMX-MINI 4