ARDES AR5R09 Instrucciones Para El Uso página 22

See the images at the end of the booklet (FIG. 1).
1. Air outlet
2. Control panel
3. Remote control
4. Base
5. Cooling pad
6. Knob
7. Water tank
Assembly (See the images at the end of the booklet).
Caution! The fan should always be switched off and does not connected
to the mains supply, if you mounting the fan.
• Assemble the 2 halves of the base together (FIG. 3-4).
• To fix the base, turn the main body upside down laying it on a soft
surface in order to avoid any damages on the upper part..
• Place the base on the fan as shown in FIG.5.
• Secure the base by turning it anticlockwise (FIG. 6).
• To disassemble the base, press the plastic part indicated in FIG. 7.
Pay attention that all the parts are correct and firmly connected with each
other.
Caution! Connect to the mains supply only after the fan has been fully
assembled.
- The fan must not be used without a fixed base.
- The device may be operated only in straight and upright position.
- This device may not be used in a horizontal position.
Fill the water tank:
• Rotate the knob in horizontal position and pull out the water tank
(Attention: the water tank cannot be opened completely).
• Fill the water tank with cold and clean demineralized water. Make
sure that water level is between "Min" minimum level and "Max"
22
Technical informations
Instructions for use
8. Cable
9. Handle
10. Air inlet grid
11. Screws
12. Ice box
13. Aroma box
GB
GB