Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
8.2 Replacing the lamp
The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from the
mains socket.
1. With your fingers, spread slightly
both sides of the transparent cover to
unhook them and detach the cover
Possible cause
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
2. Replace the lamp with the one that
3. Reassemble the lamp cover.
4. Connect the plug to the mains
5. Open the door.
Solution
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Add less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance.
pulling it in the direction of the
arrows.
1
2
1
has identical characteristics and is
specifically designed for household
appliances.
socket.
Make sure that the light switches on.
ENGLISH
13
Publicidad
