Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION:
The product you have purchased is
powered by a nickel cadmium bat-
tery which is recyclable. At the end
of its useful life, under various state
and local laws, it is illegali to dispose
of this battery into your municipal
waste stream. Please call 1-800-8-
BATTERY for information on how to
recycle this battery.
E
How to remove the built-in
rechargeable battery
before disposal of the
shaver
(see fig. 9)
The procedure described in fig. 9 is
intended only for removal of proper
disposal. Discard shaver after the
battery has been removed.
WARNING: Do not attempt to re-
place the batteries for the pur-
pose of reusing the shaver. This
could result in the risk of fire or
electric shock.
1. Remove the cap, outer foil frame,
inner blades and trimmer. (see
fig. 9A) (Trimmer must be pulled
away from main body using some
force.)
|
2. Remove the trimmer driving bar
名 an 人 two screws (a). (see fig.
9
3. Remove two screws (c) and bot-
tom cover (d). (see fig. 9C)
4. Pull the chassis out of the hous-
ing. (see fig. 9D)
5. Remove the batteries from the
chassis. (see fig. 9E)
Caution
Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will be
exposed to direct sunlight or a heat
source, or where there is a lot of
moisture.
Use only the included shaver charg-
ng adaptor RE3-70 to charge the
ES727 shaver.
The supply cord of the charging
adaptor cannot be replaced; if the
cord is damaged,
the appliance
shoutd be discarded.
Dry the shaver completely before
setting it in the charging adaptor.
Keep the charging
adaptor away from
water and handle it only with dry
hands. Do not use an extension cord
to connect the charging adaptor to
an outlet.
Do not place any metal objects like
coins and paper clips on the charg-
ing adaptor as they will become
warm,
Grip the plug when disconnecting the
charging adaptor from a receptacle;
tugging on the cord may damage it.
Store the charging adaptor and its
cord set in a dry area where it will be
protected from damage.
The outer foil is very thin. If handled
improperly, it can be easily damaged.
To avoid personal injury, do not use
the shaver if it has a damaged foil or
inner blade.
Wash the shaver in tap water. Do not
use salt water, detergent or boiling
water. Do not submerge the shaver
for a long time.
Do not wipe it with thinner, benzine
or alcohol. Clean it by cloth with
soapy water.
Do not take the housing apart as this
can affect the watertight construction.
Publicidad
