PURLINE VENTY PEGASUS Manual De Instrucciones página 15

EN
ASSEMBLY INSTRUCTIONS
-Be sure to remove all packaging material from inside the appliance.
- Ensure that the fan is switched off from the supply mains before start any installation or
assembly operation.
- Do not remove the support feet of the appliance.
- Ensure that the appliance is level with respect to the floor.
- Do not cover or obstruct any of the openings of the appliance.
- The plug must be easily accessible so it can be disconnected in an emergency.
- The appliance should be used with its base feet fitted.
FITTING THE BASE (FIG.1):
- To ensure stability of the Tripod Base, pull each leg outwards until it latches or clicks in place
on the Tripod Bracket. Place the Tripod Base upright on the floor.
- Loosen the Height Adjustment Screw and insert the Inner Pile through the hole in the Tripod
Base. Tighten the Height Adjustment Screw to fix the Inner Pipe to the Tripod Base.
- Slide the plastic Ring onto the Inner Pile from the bottom of the assembly. Fix it in place using
the screw. This prevents the Inner pipe from being pushed out when adjusting the Height.
15