PURLINE VENTY PEGASUS Manual De Instrucciones página 16

EN
ASSEMBLING THE FAN HEAD (FIG.2)
- Remove the Neck Fixing Bolt and Knob from the top of the Inner Pipe.
- Remove the Tilt Adjustment Knob from the neck of the Motor Unit; Place the neck over the
Inner Pipe with Locating Screw aligning with the slot on the side of the pole. (See Figure 2.1)
- Run the Neck Fixing Bolt through the neck of the Motor Unit and the Inner Pole and tighten
the Locating Screw leaving approximately 3mm gap under the screw head. (See Figure 2.2)
- Fix the Neck Fixing Knob to the Neck Fixing Bolt and fix the Tilt
- Adjustment Knob to the neck of the Motor Unit.
- Now you can adjust the tilt of the Motor.
- Unit and secure it in position by tightening the Tilt Adjustment Knob.(See Figure 2.3)
Fig. 2
Fig. 2.1 Fig. 2.2 Fig. 2.3
16