Publicidad
Idiomas disponibles
Idiomas disponibles
S tt
up your Fron
Door Refr erator
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator
installed in place, you are ready to set up and enjoy the features and
functions
of the appliance.
By completing
the following
steps, your Refrigerator
should
be fully operational.
1. Place the Refrigerator
in an appropriate
location with reasonable
clearance
between
it and the wall.
Refer to installation
instructions
in this manual. (page 9, selecting
the best location for the Refrigerator)
2. Once the Refrigerator
is plugged
in, make sure the interior light comes on when you open the doors.
3. Set the Temperature
control to the coldest temperature
and wait for an hour. The Freezer will get slightly
chilled and the motor will run smoothly.
4. After powering
the Refrigerator,
it will take a few hours to reach the appropriate
temperature.
You can
store food and drinks in the Refrigerator
after the temperature
is sufficiently
cool.
®
Check the accessories
listed below.
Compression fitting
83
Compression nut
Hex Wrench
Fastener
Required
Tools (Not provided)
Phillips screwdriver(+)
Flat-blade screwdriver(-)
Socket Wrench
(10mm) (for bolts)
w
Hex Wrench (3/16")
(for Mid hinge)
Pliers
REMOVING THE REFRIGERATOR
DOORS
Some installations
require door/drawer
removal to transport
the Refrigerator
to its final location.
Do not remove the door/drawer
if it is not needed.
Before removing the door/drawer
make sure you read
following
items.
zL
WARNING
®
Disconnect power to the Refrigerator before removing the door or drawer.
o
o
o
Be careful not to drop, damage or scratch the door/drawer
while removing them.
Be careful not to get injured while removing the door/drawer.
Reattach the door/drawer
properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting
energy due to improper
door seal.
10 sett]g up
Publicidad
