Publicidad
Idiomas disponibles
Idiomas disponibles
PICTURE IN PICTURE (PIP) OPERATION
PIP Operation with a VCR - No Cable Box
This television includes a Picture In Picture (PIP) feature.
A second video
source (VCR) is required to provide a second picture.
Connect your television toa VCR, as shown.
(Some modeis have only one
video input and some models have an S-VIDEO input.).
TERMINALS ON BACK OF TV
VCR
_ {may vary)__
Incoming
Cable
TO AUDIO
AMP
ETT LT LE TRIAD PROCEDE PRET
CABLES NOT SUPPLIED
Note:
The Remote Control must be programmed with the supplied codes
to operate the VCR. See Programming the Remote Control in the
Remote Control Quick Reference Guide.
Procedure
Turn the VCR OFF and tune the TV to channel 3.
Press the PIP button on the Remote Control to display the PIP frame
on screen.
Note:
The PIP picture is the same as the.Main picture, initially.
.
Press the TV/VIDEO button on the Remote Control to select
the VIDEO PIP source.
.
Press the VCR button on the Remote Control and turn ON
the VCR.
.
Press the TV/VCR button on the Remote Control.
.
Choose
channels
tor
PIP
frame
by
pressing
VCR
CHANNEL up/down buttons on the Remote Control.
.
Choose channels for the Main Picture by pressing the TV
button on the Remote Control and using the numeric keypad
or CH up/down buttons.
ax
SWE SWAP Button
The SWAP
button switches
the PIP and
Main
Picture source.
Press the RECALL button for PIP
and Main Picture source status, on screen.
Publicidad
