Concept VT8100 Manual Del Usuario página 25

EN
Note:
• Press the "+" and "-" buttons simultaneously for 2 seconds to activate the child lock. None of the control buttons will
respond. To cancel the child lock, press the "+" and "-" buttons simultaneously again for 2 seconds.
• Press the timer button (B) and the mode selection button (F) simultaneously for 2 seconds to turn off the display
backlight and the button beeps. To turn them on again, press the timer button (B) and the mode selection button (F)
simultaneously for 2 seconds.
• Pressing the timer button (B) and "-" button simultaneously for 2 seconds will lock the display of the set temperature
(if you do not do so, the temperature will automatically disappear on the display after about 1 minute). To cancel this
function, press the timer button (B) and "-" button simultaneously again for 2 seconds.
• The appliance switches off automatically after 12 hours of inactivity. This does not apply only if the timer is set to
12 hours or more.
Safety features:
• The appliance is equipped with a fall protection. When the appliance is overturned, "E3" appears on the display and
both the heater and the fan switch off automatically.
• The appliance is equipped with an audible alarm that warns that some parts of the appliance are too hot. If an alarm
sounds, turn off the appliance immediately and check that the inlet or outlet opening is not blocked by a foreign
object that may cause high temperatures. Allow the appliance to cool down for 20 minutes before using it again.
• The appliance is equipped with short-circuit protection and temperature sensor circuit protection. If these problems
occur, the warning messages "E1" and "E2" will appear on the display.
• If the room temperature exceeds 50 °C, the appliance stops working and "FF" appears on the display.
CLEANING AND MAINTENANCE
Caution!
Before each cleaning of the appliance, unplug the power cord from the electrical outlet!
Make sure the appliance has cooled before handling it!
To clean the surface of the appliance, use only a damp cloth, no detergents or hard objects, as they can damage the
surface of the appliance!
Clean and inspect the inlet and outlet grids of the appliance frequently to ensure good operation of the appliance and
to prevent overheating.
The dust in the appliance can be blown or vacuumed.
Never clean the appliance under running water, do not rinse it or immerse it in water!
CAUTION for cleaning: Do not use gasoline, benzene, thinner, aggressive detergents, etc., as this may damage the
heater. Never use alcohol or solvents.
48
SERVICE CENTRE
Extensive maintenance or repair, which requires access to internal parts of the product, has to be performed by
a qualified service centre.
ENVIRONMENTAL CONCERNS
• Packaging materials and old appliances should be recycled.
• Packaging materials may be disposed of as sorted waste.
• Dispose the plastic bags made of polyethylene (PE) of as sorted waste.
Recycling of the appliance at the end of its lifespan
This appliance is labelled in accordance with European Directive 2012/19/EU concerning used
electrical and electronic appliances (waste electrical and electronic equipment - WEEE). The symbol
on the product or on its packaging indicates that this product may not be treated as household
waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. The disposal of such material has to be done according
to the recycling regulations. For more detailed information about recycling of this appliance see the
authorized local office or service for household waste disposal or the shop, where you purchased the
appliance.
The product meets all the necessary requirements of the EU directives applicable to the specific product.
Changes in text, design, and technical specifications are subject to change without notice and we reserve the right to
change them.
VT8100 VT8100
EN
49