Sansui A-M7 Manual De Instrucciones página 8

=
=
=
O
=
ui
Copying from tape to tape
corded tape onto another tape.
le Depress the TAPE-1 input selector switch.
*
Specifications
Copying cannot be performed from tape deck 2 to 1.
Power output
Min. RMS, both channels driven, from 40 to 20,000 Hz, with no
Recording mixed sound
1.
2.
. Play the record and adjust the sound level using the VOLUME con-
Depress the PHONO input selector switch.
Plug the microphone's plug into the MIC jack.
trols.
Rotate the MIC MIXING control to the position where the micro-
phone's input level and the record sound level are about the same.
Set the tape deck to the recording mode.
Play the program source from the beginning, operate the tape deck
and start mixing recording.
The mixing recording will be cut off it the TAPE-1 or TAPE-2 input
selector switch is depressed during the actual recording.
It is not possible to monitor the mixing recording.
Depress the TAPE-1 input selector switch when recording sound
mixed with the tape sound. Use tape deck 1 for playback and tape
deck 2 fer recording. Mixing recording is not possible with tape deck
1 used for recording and tape deck 2 for playback.
Depress the TUNER input selector switch for recording sound mixed
with a broadcast.
Signal to noise ratio (short-circuit, A-network)
PHONG: 6223. 2.306.dee- rt OA ee 72 dB
Frequency response (at 1 watt)... ..
rated min. RMS power output
10 to 50,000 Hz
+0.5dB, —2dB
RIAA curve deviation (PHONO, 30 Hz to 20 kHz)
Sabie. WW lyse tae a ease OG ON eS +0.5 dB, —0.5 dB
Input sensitivity and impedance (1 kHz, for rated power output)
PHONO: :.. «4% 66 2 ere Se Re 2.5 mV/47 kilohms
(Max. input capability; 150 mV at 1 kHz, less than 0.1 % total
harmonic distortion)
AUX, TUNER, TAPE PLAY . 150 mV /47 kilohms
MWC 3. od & ne Be 0.5 mV/10 kilohms
Output level (1 kHz)
TAPE REC ...........--.8. 130 mV into 47 kilohms
For the United Kingdom only
102 watts 118 VA Rated
147 watts Maximum
Power consumption
Dimensions ................ 345 mm (13-9/16"") W
62 mm (2-7/16") H
248 mm (9-3/4"") D
WiIGKt:. 5.2.4.5. 545. 6 Mette 55.2 3.65 kg (8.1 Ibs) net
4.1 kg (9.0 Ibs) packed
Design and specifications subject to changes without notice for
improvements.
In order to simplify the explanation illustrations may sometimes
differ from the originals.
important
The wires in this mains lead are coloured in
accordance with the following code:
Blue: Neutral
Brown: Live
if the colours of the wires in the mains lead
of this equipment should not correspond to
the coloured markings identifying the ter-
minals in your plug, proceed as follows:
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter 'N' or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter 'L' or coloured red.
Ensure that your equipment is connected
correctly. If you are in any doubt, consult
a qualified electrician.
For equipment purchased outside the U.K.
with a "EUROPEAN" two-pin mains plug,
the plug should be removed and connections
made in accordance with the above instruc-
tions. Ensure also that the equipment is
properly adjusted to 240 volts operation. If
you are in any doubt, consult a qualified
electrician,or our Service Agent in the U.K.