Cleaning The Impeller - Pentair PROWLER 930 Guia De Instalacion

Ocultar thumbs Ver también para PROWLER 930:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning the Impeller

Always disconnect power to the cleaner before servicing, disassembly, or reassembly. Failure to
do so could result in death or serious injury to servicemen, pool users or others due to electrical
shock. Read all servicing instructions before servicing the cleaner.
Every so often debris may become trapped in the Prowler™ 930 Robotic Pool Cleaner' s impeller.
To clean out debris trapped in the impeller opening, follow the instructions below:
STEP 1:
Open the Filter Cover and Remove the Basket
See Figure 29 and 30.
Figure 29
STEP 2:
Unmount and Remove the Intermediate Cover and
Manifold Assembly
1.
Using a No. 2 Phillips-head screwdriver, remove
the two screws that hold the intermediate cover
and manifold assembly in place. These screws can
be found in the inside corners of the intermediate
cover. See Figure 31.
2. Place the two screws to the side.
3. Gently pull the intermediate cover (Item #2 in Figure
31) away from the cleaner and place it to the side.
4. Gently pull the manifold assembly (Item #3 in Figure
31) away from the cleaner and place it to the side.
Figure 31
MAINTENANCE
STEP 3:
Unmount and Remove the Impeller Cover
Press the tabs on both sides of the impeller cover (Item
#1 in Figure 32) to unlock the cover from the impeller
assembly. While pressing both tabs, pull the cover away
from the cleaner.
Place the impeller cover to the side.
Figure 30
STEP 4:
Clean Debris from the Impeller
By hand, remove any debris that has become trapped
around the impeller. See Figure 33.
PROWLER™ 930 Robotic Inground Pool Cleaner Installation and User' s Guide
Figure 32
Figure 33
11

Publicidad

Tabla de contenido
loading

Tabla de contenido