Storing The Cleaner - Pentair PROWLER 930 Guia De Instalacion

12
STEP 5:
Remount the Impeller Cover
Gently push the impeller cover back onto the impeller
assembly. See Figure 34.
The tabs on the motor unit will lock the cover into place.
Figure 34

Storing the Cleaner

Any time the cleaner will not be in use for an extended period of time, for example during the winter, follow the
storage recommendations below:
• Be sure to disconnect the power supply after use.
• Store the power supply, cable, and cleaner with
the caddy if included with the cleaner.
• Store the cleaner in a protected area out of direct
sun, rain and frost, at a temperature between
5°-45°C (41°-113°F).
• Drain all water from the pool cleaner.
• Thoroughly clean the filter basket and filter
screens and store the cleaner with them installed.
PROWLER™ 930 Robotic Inground Pool Cleaner Installation and User' s Guide
MAINTENANCE
STEP 6
Remount the Intermediate Cover and Manifold Assembly
Reseat the intermediate cover and manifold assembly
and reinstall the two screws that hold the cover and
manifold assembly in place. See Figure 35.
Figure 35