Caddy Assembly - Pentair PROWLER 930 Guia De Instalacion

4
PREPARATION OF THE POOL AND CLEANER

Caddy Assembly

The following section contains instructions for assembling the Prowler™ 930 cleaner caddy:
STEP 1:
Removing the Communication Cable Holder
1. While holding the caddy chassis in place, pull the top
of the communication cable holder straight out until
it snaps loose. See Figure 7.
2. Place the attachment to the side. It will be reinstalled
in Step 4.
Figure 7
STEP 2:
Installing the Caddy Wheels
1. Using two of the shorter Phillips-head screws
provided with the caddy, secure both caddy wheels
to the caddy chassis. See Figure 8.
Figure 8
PROWLER™ 930 Robotic Inground Pool Cleaner Installation and User' s Guide
STEP 3:
Installing the Handle Support
1. Slide the handle support into it' s groove on the caddy
chassis and push it firmly down into it' s seat in the
chassis. See Figure 9 .
N o te : T h e h a n d l e
support seats tightly
into the chassis and
substantial force may
be needed. Ensure the
support is seated all the
way into the chassis,
otherwise the securing
screws will not line up
correctly.
2. Using two of the shorter Phillips-head screws
provided with the caddy, secure the caddy chassis
to the handle support. See Figure 10
Figure 10
STEP 4:
Reinstall the Communication Cable Holder
1. Slide the bottom of communication cable holder into
it' s seat on the front of the caddy chassis.
2. While holding the caddy chassis in place, push the top
of the attachment in until it clicks into place Figure 11.
Figure 11
Figure 9