Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACH
iNTERMEDIATE
TUBE AND CON-
CENTRATOR
NOZZLE
Connect the intermediate tube (H) and air nozzle (I). Push
the tubes together and turn them clockwise so that they
lock together. (Fig. 7)
°O
0
.
/,
56mm
ADJUST
BACK
PACK HARNESS
AND
CONTROL
HANDLE
1.
Place blower on your back by slipping arms through
the shoulder straps as if you were putting on a jacket
(Figure 8).
2.
Once adjustments
have been made, to the straps for
user comfort, remove the blower from your back and
place on level ground in an upright position.
3.
Adjust backpack harness and control handle.
Fig. 7
Fig. 8
STARTING
A COLD ENGINE
(Above
55°1=}
Fill fuel tank with proper gas and oil mixture. See FUEL
AND LUBRICATION. Set unit upright on ground so that it
rests on the back pack frame.
1.
Pump primer bulb10 X by pressing up on the bulb(D).
(Figure 10)
2.
Your unit is designed
with a 3 position choke: FULL
CHOKE-irll-,
PARTIAL CHOKE-M,,,
and RUN "El'.
Move choke
lever to FULL CHOKE ,,Ill,,
position.
(Figure 9)
3.
Set throttle lock (C): While holding trigger (B) at wide
open position, press down and hold throttle lock (C).
Release throttle trigger (B), then release throttle lock
(C). Throttle trigger (B) will now remain in the wide
open position. Make sure ignition switch is in the ON
(I) position. (Fig. 11)
Fig. 10
c
\
A
Fig. 11
Fig. 9
10
Publicidad
