Publicidad
English
1. Install the HDD
If the kit does not include any HDD, please prepare it by yourself. You are
recommended to use the HDD dedicated for surveillance.
Tips
When installing or replacing the HDD, please cut off the power supply of the NVR first;
otherwise, the HDD may not be detected or even be damaged.
Unfasten the screws on the bottom, then remove the cover of the NVR.
Reserve the screws for later use.
Take out 2 screws from the NVR installation package, and screw them
into the two screw holes closest to the SATA connector. Reserve about
2 mm between the screw head and the HDD for subsequent installation.
SATA connector
Remove the cover
Flip
POWER
PoE PORTS
1 3
IN
2 4
OUT
LAN
AUDIO
HDMI
VGA
USB1 USB2
Publicidad
