Greencut SRM120C Manual De Instrucciones página 55

BLADE PROTECTION FOOT ADJUSTMENT
When cutting at an angle, the blade guard foot must be adjusted so that it is parallel to the table and flat above the
workpiece (Fig. 5 and 6).
1. To adjust, loosen screw (2), tilt foot (1) parallel to table and tighten screw.
2. Loosen the height adjustment knob (3) to raise or lower the foot until it rests on the top of the workpiece.
Tighten the knob.
Fig. 5
POWDER BLOWER ADJUSTMENT
• For best results, the powder blowing tube (1) should be adjusted to direct air
to both the leaf and the workpiece (Fig. 7).
SAWDUST COLLECTION PORT
• This marquetry saw allows a hose or vacuum attachment (not supplied) to be connected to the sawdust collection
hole (1). If too much sawdust accumulates inside the base, use a vacuum cleaner or manually remove the sawdust
by removing the screws (2) and the metal plate on the left side of the saw. Replace the metal plate and screws
before starting the saw (Fig. 8 and 9).
Fig. 8
1
2
1
Fig. 6
1
1
Fig. 9
2
55
EN
Fig. 7