Scheppach TIGER 2000S Traducción Del Manual De Funcionamiento Original página 29

- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
15. Troubleshooting
Problem
Engine does not run.
The engine starts slowly
and does not reach the
operating speed.
Engine producing
excessive noise.
Engine does not reach
full power.
Motor overheats easily. Overloading of the engine,
Possible cause
Engine, cable or connector
defective, fuses burnt.
Voltage too low, coils damaged,
capacitor burnt.
Coils damaged, motor defective.
Circuits in the network are overloaded
(lamps, other engines, etc.)
insufficient cooling of the engine.
www.scheppach.com
Remedy
Have the machine checked by a specialist. Never
repair the engine yourself. Attention! Check the
fuses and replace them if necessary.
Have the power supply company check the
voltage. Have the engine checked by a specialist.
Have the capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other devices or engines on the
same circuit.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum
engine cooling.
GB | 29