Omnitronic UHF-400 BP Manual Del Usuario página 11

Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the 2 mignon-batteries (type AA) and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.
5.2 Start-up
Screw the microphone lead into the microphone input socket.
Attach the pocket transmitter via the belt clip to the belt or waistband.
With the operation selector, you can switch the device on and off. When switching the device on, the red
LED shortly lights up. In this case, the power supply is sufficient.
When the battery is getting weaker, the red LED is permanently illuminated. In this case, the batteries have
to be replaced.
If the red LED does not light up when switching on, there is either no battery inserted or the poles are wrong.
Please note that the operation selector has to be set to ON in order to transmit microphone signals.
Via the Gain control in the battery compartment, you can adjust the microphone sensitivity. Use a screw-
driver in order to turn the control until the desired sensitivity is adjusted.
11/22 00023849.DOC, Version 1.3