Publicidad
Idiomas disponibles
Idiomas disponibles
MOTOR
PULLEY
ASSEMBLY
To assemble motor pulley to motor shaft, back off the
two set screws in pulley so that pulley can slide onto
motor shaft. Make certain that the set screw side is
toward the motor body. Align the key in the motor shaft
with the key way in pulley. Slide pulley onto shaft until
end of shaft is flush with face of pulley.
Motor Pulley
Figure 12
A_
D
BELT ASSEMBLY
AND
PULLEY
ALIGNMENT
,
,
,
Place V-belt in groove of cutterhead pulley and
motor pulley.
Belt
To properly align motor pulley to the cutterhead
pulley, place a straight edge on the outside face of
the cutterhead pulley. The motor and motor pulley
can be moved in or out and up or down until the
outside face of the motor pulley is vertically aligned
with the cutterhead pulley.
After proper alignment, tighten all bolts that attach
motor to dust chute.
4.
Tighten both set screws.
BELT TENSIONING
,
,
,
Proper belt tension is achieved when there is
approximately
1" deflection at the center of the belt
span using light finger pressure.
To achieve proper belt tension, loosen the four
motor attachment bolts. The motor can be moved
up or down to gain proper tension.
After achieving proper tension, check that there is
proper alignment of the pulleys. Then tighten all
bolts attaching the motor to the dust chute.
CUTTERHEAD
PULLEY
GUARD ASSEMBLY
To assemble the cutterhead pulley guard (A) to the
stand (B), place the guard over the cutterhead pulley
located at the rear side of the jointer. Align the two holes
(C) in the guard with two holes in the top plate of the
stand. Attach guard to stand with screws (D),
flatwashers (E), and hex nuts (F) provided.
See Figure 12.
Cutterhead Pulley Guard
M6 x 12mm Hex Head Screw (qty. 2)
M6 Flat Washer (qty. 2)
M6 Hex Nut (qty. 2)
FENCE CARRIAGE
ASSEMBLY
,
From the fence assembly (9) Fig. 4, remove the
E-clip (A), special hex nut (B), washer (C) and slide
trunnion bracket (D) from the bevel lock rod (E).
See Figure 13.
Fence Assembly
Figure 13
J
H
C
J
D
B
A
E
12
Publicidad
