Publicidad
Idiomas disponibles
Idiomas disponibles
Press the key MODE to select USB, SD / MMC, Bluetooth mode or to start recording what is
being played on a USB or SD card.
Press the key
in the playback mode to start or pause it. Long press to erase what is cur-
rently recorded. In recording mode, press this key to stop recording.
B LU E TOO T H CONF I GUR AT I O N
When the tonearm is on the clamping piece, the Bluetooth function starts automatically.
Press the key MODE to switch between USB, SD and Bluetooth functions.
1. Open the tone arm clamp.
2. Remove the protective cap from the head to expose the needle.
3. Carefully separate the head from the rest of the tone arm.
4. Completely disconnect the audio cable from the head.
5. To replace the new head, snap the audio cable back into place.
6. Install the head back onto the tone arm.
7. Put the protective cap back on the head to protect the needle.
Note: Take special care while changing the head to avoid damage to the boom or the audio
cable. The turntable head should be replaced every 3 to 4 months of continuous use. Ceramic
heads are easily found in specialist stores and websites.
1. The device is connected but not working.
Make sure the turntable is connected to power and check that you have turned it on and
turned up the volume.
2. Strange sound is heard from the speakers.
Check that the vinyl record is not damaged. Also, make sure the needle is in good condition
and should not be replaced. (The needle should be replaced every 3 ~ 4 months of continuous
use.) Do not turn the volume to maximum to avoid distortion in the sound.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances in elec-
tric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on the package
indicates that the product at the end of its service life shall be collected as separate waste. Therefore, any products that
have reached the end of their useful life must be given to waste disposal centres specialising in separate collection of
waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment,
on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible negative effects on the
environment and health and optimises the recycling and reuse of components making up the apparatus. Abusive disposal
of the product by the user involves application of the administrative sanctions according to the laws.
E NGL I SH
10
HOW TO REPLACE THE NEEDLE HEAD
PROBLEM RESOLUTION
Publicidad
