Create Record Player Compact Manual De Instrucciones página 9

1. Connect the smaller end of the power cord to your turntable.
2. Plug the larger end of the power cord into the wall outlet.
3. Place the vinyl record on the turntable.
4. Set the correct speed (rpm) for playing your vinyl record (33/45/78 RPM). For 45 RPM
drives, use the RPM adapter.
5. Turn on the turntable by turning the controller.
6. Place the tone arm over the desired playback point on your vinyl record. The turntable will
start playing the music.
7. Adjust the volume of the speakers to the desired level.
8. Activate the auto stop control to stop the disc spinning when the tracks finish playing.
9. You must put the tone arm back onto the clamping piece.
HEAD P H ONE OU T
Connect headphones to this output to listen to music. Headphones are not included with the
turntable.
Note: When using headphones, sound will no longer come out of the speakers.
RCA AUD IO OUTPU T
It allows you to play the music from your turntable through external speakers. To make this
connection you need an RCA cable that is not included with the turntable.
PL AY 45 R PM V INY L RECO RDS
Place the 45 RPM adapter on the center shaft. Carefully place a 45 RPM record on the turn-
table. Follow the turntable's operating instructions to start playback.
RE P L ACE THE H EAD
The turntable head should be changed every 3 ~ 4 months after continuous use.
U SB / SD DR IV E RS
This panel allows the user to play music from USB memory devices, SD cards, Bluetooth
connections or the auxiliary function (Aux) or even record.
RECORD IN G
While playing a vinyl, just press (about 3 seconds) the key MODE. Then the device starts
recording music while flashing a green light until you press the key
Remember you can only record from vinyl to USB / SD cards.
Press to play the previous songs.
Press to play the next songs.
RECORD PLAYER OPERATION
to stop recording.
E NGLI SH
9