IKRA HGSI 45 FS Instrucciones De Manejo página 32

Worn out electrical appliances and batteries do
not belong with your household waste.
Electrical appliances must be collected, recycled
or disposed of in an environmentally friendly
manner.
Defective or spent batteries must be recycled properly
in accordance with the latest regulations concerning bat-
tery and accumulator disposal.
Before removing the installed accumulator with printed
board from your appliance, actuate the ON/OFF switch
and wait until the accumulator has fully discharged.
Then use a screwdriver to undo all screws on the appli-
ance and open the casing.
Remove the printed board with lithium ion cell and
disconnect the connections on the accumulator/printed
board.
We, ikra GmbH, Schlesierstrasse 36, 64839 Münster, Germany, declare under our sole responsibility that the
product/s Accu Grass- and Shrub shear HGSI 45 FS, to which this declaration relates correspond to the relevant
basic safety and health requirements of Directives 2006/42/EC (Machinery Directive), 2014/30/EU (EMV-Guideline),
2011/65/EU (RoHS-Guideline) and 2000/14/EC (noise directive) incl. modifications. For the relevant implementa-
tion of the safety and health requirements mentioned in the Directives, the following standards and/or technical
specification(s) have been respected:
EN 60745-1/A11:2010, EN 60745-2-15:2009/A1:2010,
EN 55014-1/A1:2009+A2:2011, EN 55014-2/A2:2008
EN 60335-1:2012/A11:2014
EN 50636-2-94:2014, EN 50581:2012
EN 62233:2008, AfPS GS 2014:01 PAK
measured acoustic capacity level
guaranted acoustic capacity level
Conformity assessment method to annexe V / Directive 2000/14/EC
The year of manufacture is printed on the nameplate and can be additionally retrieved via the consecutive serial number.
Münster, 19.10.2016
Maintenance of technical documentation: Gerhard Knorr, Kärcherstraße 57, DE-64839 Münster
GB | Operating Instruction
Then hand in the printed board with lithium ion cell at an
accumulator/battery recycling point for proper disposal.
In line with the European Electrical and Electronic Equip-
ment Directive, after removing the printed board with
accumulator, you must deliver the appliance for environ-
mentally friendly recycling.
We would, however, also be happy to handle the proper
disposal of the appliance with accumulator on your
behalf. To take advantage of this offer, send the appli-
ance to the service address provided in the operating
instructions.
Repair service
Repairs to electric power tools should only be carried out
by specialist electrical personnnel.
EC Declaration of Conformity
87 dB (A)
92 dB (A)
Gerhard Knorr, Technical Management Ikra GmbH
GB-9