Celexon Adjust-42100M Manual De Instrucciones página 16

STEP 2 I MOUNTING THE DISPLAY HOLDER
Turn the chassis over with 2 people so that it stands on the castors.
Screw the connecting element to the motor head with the hexagon socket
screws (M6x20). We recommend that you first screw on the rear and then
tighten the two front screws. This is to prevent the struts from leaning forward
during later use.
Take the two horizontal cross struts and insert them into the recesses provided
for this purpose in the connecting elements. Screw them together with the
hexagon socket screws M6x70. Use the enclosed washers and the
corresponding locking nuts.
Note: For saftey reasons, the fasteners may only fit very tightly into the
recesses. Press them in firmly with two people if necessary.
Fig. 4
Fig. 6
Fig. 5
Fig. 7
5