Publicidad
Idiomas disponibles
Idiomas disponibles
DOOR REVERSAL
To facilitate door reversal, we recommend someone assist you during this process.
Tools required: Phillips Screwdriver
1. Lay the unit in it's back.
2. Open the door until the screws securing the lower door support bracket are exposed on the bottom of the door
This will require the door to be opened to a 90 degree angle.
Remove the screw closest to the bracket, as shown if Fig #1.
This will require someone to hold the door in the open position while the screw is being removed.
3. Close the door.
4. Remove the remaining screw in the lower door support.
5. Lift the door upwards and remove from the cabinet of the wine cooler.
6. Remove the 3 screws each securing the top and bottom hinge.
NOTE: Keep these hinges in a safe place in the event you ever need to revert back to a right hand door swing.
7. Remove the plastic screw caps from the left hand side of the door frame.
There are six (6) plastic caps to be removed.
8.
Install the left hand top and bottom hinge (supplied with the unit) There are three (3) screws for each hinge.
9.
Insert the lower door support onto the bottom hinge.
Do not secure with screws until the door is installed.
10. Carefully re-position the door onto the lower door support and cabinet.
11. With door closed against the cabinet install one screw into the lower door support bracket.
12. Open the door to 90 degrees and install the second screw.
13. Close the door and check the door alignment and gasket seal.
14. Install the plastic screw caps in the right side of the cabinet.
15. Return the wine cooler to it's upright position.
16. Check the door again for proper sealing.
NOTE: Allow the unit to stand upright for 1 hour before putting the unit into operation.
3
Publicidad
