Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION:
Before turning on the wine cooler, ensure that the cabinet is level. This will eliminate any vibrations.
NOTE: The power (RUN) indicator light is located on the LED control panel inside the unit and will illuminate
when the compressor (cooling) cycle is operational. Set the desired cooling temperature by pressing the
buttons adjacent to the "upVdown" arrows.
Each depression of the buttons will increase/decrease the set
temperature in increments of 1 degree. The set temperature will be displayed in the LED (TEMPSET) window.
It is possible to display temperatures in either Celsius or Fahrenheit. To change the setting, press and hold
both buttons simultaneously for approximately 5 seconds.
The blue
pilot light adjacent to the mode
selection will illuminate the selection made.
r
TEMP.SET
DISPLAY
RUN
o
Activation
i
°C
°F
*
OA
ov
REGLAGE DE TEMP.
AFFICHAGE
To temporarily disconnect the cooling cycle, unplug the wine cooler. When disengaging the cooling function
for long periods of time, disconnect the plug and leave the door partially open.
NOTE: Wait 3 to 5 minutes before restarting the wine cooler if operation has been interrupted.
INTERIOR LIGHT
The interior light can operate "manually" or "automatically". The light automatically comes on with the opening
of the door and goes out when the door is closed. To operate the light manually, press the light/toggle switch
located at the bottom right of the wine cooler exterior cabinet to the "on" position. To turn the light off, toggle
the switch to the "off" position.
DEFROSTING/CONDENSATION
Your wine cooler is designed with an "Auto-Cycle" defrost system. During the "Off Cycle" the refrigerated
surfaces of the wine cooler defrost automatically. Defrost water from the wine cooler storage compartment
drains automatically, and is channeled into a condensate drain pan which is located in the back of the wine
cooler next to the compressor. The heat transferred from the compressor evaporates any condensation that
has collected in the pan.
CARE & MAINTENANCE
Upon receiving your wine cooler, leave the door open for 24 hours. When cleaning the inside of the wine
cooler you can use a solution of a tablespoon of baking soda to one (1) quart of water, or a mild soap suds
solution, or some mild detergent. Wood shelving does not require cleaning. To clean the exterior cabinet of
your wine cooler, use a soft damp cloth with mild detergent or appliance cleaner.
4
Publicidad
