Descargar Imprimir esta página

Craftsman 138.99026 Manual Del Operador página 9

Recortador de hierba y rebordeador inalambrico a baterjas de ion de litio de 40v

Publicidad

Idiomas disponibles

Idiomas disponibles

_kWARNING:
To avoid injury:
• Do not squeeze the trigger while the grass
trimmer/edger
is inverted.
Do not carry the grass trimmer/edger
with your
finger on the switch. Avoid unintentional starting.
To Turn On / Off :See Figure 8, page iii.
1. Press the safety lock out button (2) and squeeze
the trigger switch (1) to start.
2. Release the trigger switch (1) to stop.
,_
CAUTION:
Always allow 5 seconds or more for the cutting
line spool to stop rotating after releasing the
trigger switch. Do not invert the grass trimmer/
edger, or place your hands under the protective
guard until the grass trimmer/edger
spool has
come to a complete stop.
Edging
FunctionSee
Figure 9, page iii.
For use next to patios, driveways
and walkways
or
any areas requiring a well groomed
edge line.
1. Push on the edge button (1) and tilt the trimmer
head 90 degrees until the head locks into position
and release button.
IMPORTANT: The battery must be removed
before making adjustments
Pivoting Head Function
Adjust pivoting head to trim hard to reach areas and
for user comfort.
(See Figure 10, page iii)
Lengthening
the Line
While the grass trimmer/edger
is operating,
the
cutting line gets worn down and becomes shorter.
This trimmer is equipped with Automatic
Line
Advancement
which automatically
feeds additional
line to the correct length as it wears down. If the
line does not auto advance the trimmer line may
be tangled or empty. To advance the line, stop
and restart the trimmer. Upon starting, the line will
automatically
advance 1/4" (6.4 mm).
Trimmer Tips
If the battery must be stored
in a warm place,
charge it frequently.
Before trimming,
inspect the area for string, wire,
branches
or other
material
that may become
entangled
in the cutting line and thrown.
During use
Trim only when the grass and weeds are dry.
Do not trim grass at night. Always make sure you
have adequate lighting.
Hold the grass trimmer/edger
by both the switch
handle and the auxiliary handle for best control
and balance.
Stand with the cutting head tipped down at an
angle in front, guiding the grass trimmer/edger
in
a semicircular
motion around you.
If possible,
guide the grass trimmer/edger
to the
left to cut.The
line will cut as soon as it leaves
the guard, and the clippings
are thrown away
from you.
To produce a smoothly trimmed
area, move the
grass trimmer/edgermout
of the area being cut
with consistent
speed and height.
Use only the tip of the cutting
line to do the
trimming,
especially
near
walls
and
fences.
Trimming
with the side of the cutting
line may
overload the motor, wear out the line faster, and
break the line more often.
Do not rest the trimmer
spool on the ground
while trimming.
This will cause spool wear and
battery drain.
If the grass
is higher
than 6" (15 cm), trim in
small stages.
When the grass trimmer/edger
is turned off and
the spool stops rotating, the cutting line will relax
and may recede. Feed extra cutting
line before
storing the trimmer
to prevent
losing
the line
completely
into the spool.
If the diameter of the cutting area gets smaller,
the line is worn down and needs to be advanced
more often.
If the grass trimmer/edger
is not cutting correctly,
the cutting
line may not be feeding
properly.
Remove and rewind the line spool.
9 -- English

Publicidad

loading