Craftsman 917.377521 Manual Del Propietário página 8

DRIVE CONTROL
o Self-propelling is controlled by holding
the operator presence control bar down
to the handle and pushing the drive
control lever forward until it clicks; then
release the lever°
= Forward motion wilt stop when the
operator presence control bar is
released. To stop forward motion
without stopping engine, release the
operator presence control bar slightly
until the drive control disengages. Hold
operator presence control bar down to
handle to continue mowing without self-
propelling.
= To keep drive control engaged when
turning corners, push down on handle
and lift front wheels off ground while
turning lawn mower.
Operator presence control bar
Drive
To engage drive Drive controJ
control desengaged
BEFORE STARTING ENGINE
OIL
Your lawn mower is shipped without oil in the
engine.
o Be sure mower is level and area around oil
fill is clean.
= Remove engine oil cap w/dipstick and fill to
the full line on the dipstick.
o Use 20 ozs. of oil. For type and grade of oil
to use, see "ENGINE" in Customer
Responsibilities section of this manual.
= Pour oil slowly. Do not over fill
- Check oil level before each use. Add oil if
needed. Fil! to full line on dipstick.
° To read proper level, tighten engine oil cap
each time.
o Reinstall engine oil cap and tighten.
° Change the oil after every 25 hours of
operation or each season° You rnayneed
to change the oil more often under dusty,
dirty conditions.
ADD GASOLINE
o Fillfuel tank_ Use fresh, clean, regular'
unleaded gasoline with a minimum of 87
octane. Do not mix oilwith gasoline.
Purchase fuel in quantities that can be used
within 30 days to assure fuel freshness_
IMPORTANT: When operating in
temperatures below 32°F(0°C), use fresh,
clean winter grade gasoline to help insure
good cold weather starting.
WARNING: Experience indicates that alcohol
blended fuels (called gasohol or using ethanol
or rnethanol) can attract moisture which leads
to separation and formation of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage. To avoid
engine problems, the fuel system should be
emptied before storage of 30 days or longer:
Drain the gas tank, start the engine and let it
run until the fuel lines and carburetor are
empty. Use fresh fuel next season. See
Storage Instructions for additional information.
Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
CAUTION: Fill to bottom of gas tank filler
neck. Do not overfill. Wipe off any spilled
oil or fuel. Do not store, spill or use
gasoline near an open flame.
Ga= filter cap Engine oil cap w/
dipstick
TO START ENGINE
• To start a cold engine, push primerthree
(3) times before tryingto start. Use a firm
push_ This step is not usually necessary
when starting an engine which has already
runfor a few minutes,
o Hold operator presence control bar down to
the handle and pull starter handle quickly.
Do not allow starter rope to snap back.
o To stop engine, release operator presence
control bar.
NOTE: In cooler weather it may be
necessary to repeat priming steps. In
8