Publicidad
Idiomas disponibles
Idiomas disponibles
Connect water suciion hose to the INLET connector. We
After checking that the primary voltage
recommend the use ofa reinforced suction hose with internal
is the same as shown on the motor label,
\ diameter not less than 1⁄2 inch.
1. Now you can turn on the water.
|
2. Setthe pressure to zero by turning the knob counterclock-
Wise.
3. Hold the gun in the open position for a few seconds to
allow the air to escape from the hoses.
4. Switch on the unit.
you may proceed to plug the unit in.
5. At this point adjust the machine to your pressure require-
ment (up to 1000 PS!) and you are ready to do your work.
BW200
Page 9
Publicidad
