Maintenance; Carry Out The Following Periodic Checks On The Power Source - voestalpine bohler welding TERRA NX 270 TLH Manual De Instrucciones

Control panel functions
"0".
5.2.2 Circuit resistance calibration (set up 705)
705.
705.
10.0

6. MAINTENANCE

Routine maintenance must be carried out on the system according to the manufacturer's instructions. When the
equipment is working, all the access and operating doors and covers must be closed and locked. The system must
not be modified in any way. Prevent conductive dust from accumulating near the louvers and over them.
Any maintenance operation must be performed by qualified personnel only. The repair or replacement of any parts
in the system by unauthorised personnel will invalidate the product warranty. The repair or replacement of any parts
in the system must be carried out only by qualified personnel.

6.1 Carry out the following periodic checks on the power source

6.1.1 System
0
Parameter selection
Calibration
screen.
51
MIG/MAG
0
MAINTENANCE
EN
MIG/MAG
MIG/MAG