MPM MCZ-116 Manual De Instrucciones página 15

USE OF THE KETTLE
1. Before using the kettle for the first time, boil water in it at least twice and pour it out.
2. Before filling with water, remove the jug from the base (7).
3. Open the lid of the jug with the button (lever) (3) and fill it with water to the desired level (but not
less than the MIN dash (0.5l) and not more than the MAX dash (1.7 l). Close the cover (2) carefully.
4. Place the kettle on the power stand (7). Turn on one of the three functions of the kettle:
A. Cooking - to boil water, press the ON/OFF button (A) on the control panel (5)
B. Heating (temperature range: 50;70;80;90) - the temperature is set by pressing the temperature
control button (B) located on the control panel (5). The current selection will be indicated on the
control panel (5) by the illumination of the LED located under the marking with the temperature
indication (C). Press the ON/OFF button (A) to confirm the selection.
C. Temperature maintenance (temperature range: 50;70;80;90) - select the temperature by follo-
wing the same procedure as for heating. Confirm the selection by holding down the ON/OFF
button (A) for about 2 seconds, until the LED located under the currently selected temperature
(C) starts flashing. Temperature maintenance is active for 30 minutes, after which the kettle
will turn off.
CAUTION! Once the kettle starts working, the inside of the kettle will be illuminated with a color
specific to the selected temperature .
CAUTION! Use of the buttons located on the control panel is further indicated by a single beep
CAUTION! The end of the kettle's operation is signaled by a double beep and the illumination of
the control panel and the interior of the kettle going out.
5. When the kettle is finished working, it will turn off automatically. In addition, the operation of the
kettle can be interrupted, at any time, by pressing the ON/OFF button (A).
6. After boiling water or turning off the kettle, wait about 15-20 seconds before turning it back on.
If the kettle is turned on without water, the overheat protection system will turn it off. You should
then let the kettle cool for about 15 minutes before refilling it again.
CLEANING AND MAINTENANCE
Clean the kettle frequently of limescale. Use limescale removing chemicals dedicated to electric ket-
tles (and use the instructions for use of the chemical) or a mixture of water with vinegar or citric acid.
Failure to descale the kettle may result in its failure. Wipe the kettle clean inside and out with a cloth.
Do not clean with a wire brush, scouring pads or strong detergents.
TECHNICAL SPECIFICATION
See the product's nameplate for technical specifications.
Power cord length: 0.65 m
Proper disposal of the product (waste electrical and electronic equipment)
Marking on the product indicates that after the service-life of the product expires, it should not be dis-
posed with other type of municipal waste. Used equipment may have a negative impact on the environ-
ment and health of people due to potentially containing hazardous substances, mixtures and components.
Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may
cause a release of substances that are hazardous to the environment and health. Used equipment should
be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the
electric waste collection points, the user should contact the municipal point of electric waste collection or used
equipment processing department.
EN
15