Publicidad
Idiomas disponibles
Idiomas disponibles
EN
USE
CAUTION! A small amount of smoke may come out of the device during the first use. This is
normal.
CAUTION! After finishing work, in order to remove hot fumes from the device, the fan will con-
tinue to work for approx. 20 seconds.
CAUTION! The device is protected against improper use; the device will not turn on without a
properly installed basket (2), the control panel (3) will remain completely blank.
1. Connect the device to the grounded mains. The device will signal established connection with the
network using a single beep. Additionally, the entire control panel will light up briefly. After turning
off, only the
2. Pull out the bowl with the basket by pulling the handle (1).
3. Put products into the basket (2).
CAUTION! Do not fill the basket (2) above the "MAX" mark or exceed the maximum amount of
ingredients given in the table (see: "COOKING - TIPS" section).
4. Slide the bowl with the basket back into the Fitfryer by holding the handle (1).
5. Wake up the device from sleep mode by pressing the button once
control panel and activate all functions.
6. Set time and temperature:
a. Manually (80-200C° / 1-60 min.); the temperature can be set by pressing the adjustment but-
tons
and
the display located in the central point of the control panel (3).
b. Default Programs - The device supports seven default programs. Press the menu
select the default programme. The currently selected program will be signalled by one of the
seven flashing icons located at the top of the control panel (3).
Additionally, the device is equipped with a heating function; use the button marked with the
symbol in order to select it.
7. Start the device - after selecting the time and temperature, press the
tion, the display will alternately show the set temperature and the time remaining to turning off.
CAUTION! The time and temperature adjustment buttons are active after starting the device;
operating parameters of the device can still be changed.
CAUTION! Pressing the
To resume the program, press the
1 minute, the device will change operation into sleep mode.
8. Signalling operation on the control panel - until the program is confirmed, the
and goes into continuous
of the device is signalled by a flashing bar on the control panel (3) located under the icons with the
selection of default programs.
9. Ending the operation - the device will turn off automatically when the set time comes to an end.
The end of operation will be signalled by the display of the word "OFF" on the display, accompa-
nied by a sound signal; then the device will go into sleep mode. The operation of the device can be
ended at any time by pressing the
disconnected from the power source.
COOKING - TIPS
The range of dishes one can prepare with the device is vast; for choosing the correct weight of food
and the optimal baking time, please refer to the table below.
32
button will remain visible; the device will then go into sleep mode.
and
located next to the
located next to the
button during operation for about 1 minute, suspends the program.
illumination after the operation is started. In addition, the operation
icon. Set the time by pressing the adjustment buttons
icon. The selected operating parameters will be visible on
button again. If the
button . After the operation is finished, the device should be
; this will light up the entire
button. During opera-
button is not pressed again within
button flashes
button to
Publicidad
