Dometic TD283 Guía De Instalación Y Funcionamiento página 9

Pos. in A Compo- Description
nent
Shows the selected menu.
Menu
2
display
As start screen, the main menu is displayed.
Via the menu bar, the main and settings menu as well as the menus for connected devices can be se-
lected.
The menu for currently connected devices is shown in white, the menu for active devices (status
"On") is shown in yellow and the menu for devices that are not connected is grayed out. Grayed out
menus are not selectable.
3 Menu bar
Error indication
A red dot on the bell indicates that an error has been detected. The error messages can
be called up by pressing the bell.
Power button
Switches the display to standby.
Main menu
The following is displayed (see Fig. , B):
• Status (On/off) and voltage (in V) of the starting battery (1)
• Status of the battery charger (Standby/Bulk/Absorption/Float/Off) and power
supply (in A) from the battery charger (2)
• Status of the inverter (On/Off) and power supply (in A) from the inverter (3)
• Status of the solar charge controller (Standby/MPPT/Absorption/Float/Off) and
power supply (in A) from the solar charge controller (4)
• State of charge of the house battery (circle diagram in 5/25 % steps) with current
values for voltage (in V) and current (in A) (5)
Settings menu
• Bluetooth: Activating or deactivating the bluetooth function of connected N-BUS
devices with bluetooth function.
• Silent Mode: Activating or deactivating the silent mode. With silent mode acti-
vated, the fan (if present) of connected N-BUS devices is switched off and the de-
vices charge at reduced power to prevent overheating.
• Display: Setting a timer (in min) for dimming the backlight and switching the dis-
play to standby. Setting the button and warning tone signals (BEEP).
• Battery: Setting the type and rated capacity of the connected house battery.
• Charging Profile: Setting the charging profile suitable for the connected house
battery.
• Solar Panels: Setting the nominal output (in Wp) for connected solar panels.
• Date&Time: Setting the date and time.
• Language: Setting the language.
• N-BUS: Opening an overview of connected N-BUS devices.
7