Publicidad
Idiomas disponibles
Idiomas disponibles
Control Set
GB+USA
3 The Receiver
View Receiver (Fig. 2, Pg. 1)
Power Supply (1)
Cable for the 9V power supply. Attach the red connector to the red cable (+) and attach the green connector to the green
cable (-). You can use the ACCU set (not included in this package). Only the aforementioned power supplies may be used.
D LED (2)
The operation display LED is lit, if the power supply is connected. It flashes, if data is being received.
D Infrared Receiver Diode (3)
The IR receiver diode receives the transmitter's signal. The receiver should be installed in your model, so that the receiver diode
faces upwards. The receiver can thereby receive the signal from the transmitter unobstructed.
D Servo Connection (5)
Connection for the fischertechnik servo (article nr. 132292)
D Servo Trimmer (4)
The trimmer is used for calibrating the neutral position of the servo. By adjusting the trimmer you can, for example, calibrate the
steering of your model, so that it moves exactly straight forward when the steering joystick is in the neutral position.
D Motor Connectors M1 - M3 (6, 7, 8)
Motors M1 - M3 can be attached here to the connectors. If you want to change the rotational direction, you can simply interchange
the connectors of a motor.
D DIP Switch (9)
The positions of DIP switches 1 and 2 on the receiver and on the transmitter must match, in order for any signal to be transmitted
to the receiver (see page 4). The positions of DIP switches 1 and 2 on the receiver and on the transmitter must match, in order for
any signal to be transmitted to the receiver.
DIP Switch 3
ON
With this switch, caterpillar functions (for tracked vehicles) can be switched on. For a description of
caterpillar functions, see Chapter 5.
In this position, the caterpillar function is not selected.
1
2
3
ON
In this position, the caterpillar function is selected.
1
2
3
12
Publicidad
