Publicidad
Idiomas disponibles
Idiomas disponibles
3 USING THE APPLIANCE
3.1 Display and Control Panel
1
Using the Control Panel
1. Fridge temperature set button
2. Super cooling symbol (Super cooling
LED)
3. Alarm symbol (Alarm LED)
4. Fridge adjusted temperature indicator
3.2 Operating your Fridge
If your product has lighting
When the product is plugged in for the
first time, the interior lights may turn
on 1 minute late due to opening tests.
3.2.1 Fridge Temperature Set Button
This button allows setting temperature of
the fridge. In order to set values for fridge
partition, press this button. Use this button
also to activate super cooling mode.
3.2.2 Alarm symbol (Alarm LED)
In case of a problem within the fridge, the
alarm led will release red light.
3.2.3 Super Cooling Mode
When would it be used?
• To cooling huge quantities of food.
• To cooling fast food.
• To cooling food quickly.
• To store seasonal food for a long time.
How to use?
• Press temperature set button until super
cooling light comes on.
• Super cooling led will light during this
mode.
2
3
EN - 31
4
• For optimal appliance performance
in maximum cooling capacity, set the
appliance to active super cooling mode 2
hours before you put the fresh food into
the fridge.
During this mode:
If you press temperature set button, the
mode will be cancelled and the setting will
be restored from 2.
The super cooling mode will be cancel
automatically after 5 hours.
3.2.4 Fridge Temperature Settings
• The initial temperature of the setting
display is 5 °C.
• Press fridge setting button once.
• Every time you press the button, the
setting temperature will increase. (2 °C,
4 °C, 5 °C, 6 °C, 8 °C, Super cooling)
• If you press fridge setting button until
super cooling symbol is displayed on
your fridge.
• Settings display and you do not press
any button within the following 3 seconds.
• Super cooling will blink.
• If you keep on pressing, it will restart from
last value.
Note:Some built-in appliances may have a
stand-by mode.
3.2.5 Stand-By Mode
How To Activate ?
Set "2" set value and push set button until
all leds are blink three times.
Publicidad
