GET SX1 LC-GPA Guia página 8

D. SX1 LC-GPA OPERATION
Once the motorcycle has started, SX1 LC-GPA will perform an automatic check of
operation, turning on all LEDs.
GPA DISPLAY MODE
GPA Display Mode
LC
MFL
SHIFT LIGHT
Shift light
5
6
4 7
3 8
2 9
LC
1 10
MFL
EN
After the first automatic check, the LEDs will turn on fixed, showing
the GPA ("Traction Control") level set (e.g., 3 LEDs = GPA lev. 3).
NOTE: On its first installation SX1 LC-GPA will show level 5 as
factory setting.
- If the GPA level is set to level 0 no LEDs will turn on.
To understand how to change and set the GPA level, see the
section "GPA Setting Mode".
While on GPA Display Mode, once a specific RPM threshold is
reached (i.e., 750 RPM below the limiter), all blue LEDs will flash.
This is the Shift Light indicator that suggests the rider to shift up
the gear.
NOTE: The Shift Light threshold can be edited using GET Maya
programming software (sold separately).
8