BWT RC60 Instrucciones De Funcionamiento página 6

Maintenance and Storage
Cleaning the filters
The filters must be cleaned after each cleaning cycle. (1) Release the
filter and pull it out of the cleaner unit. (2) Open the filter case. (3) Spray
water on the outer sides of the filter and then spray water towards the
inner side of the filter to clean all the dirt and debris. (4) Reinsert the filter
back into its location until a click is heard to secure the filter in place.
Storing the robotic cleaner
Follow these instructions to store the robotic cleaner when not in
use: (1) Disconnect the power cord from the wall outlet. (2) Disconnect
the floating cable from the power supply. (3) Spread out the floating
cable, and roll it. (4) Wash the cleaner unit interior and exterior space
with fresh water and let it dry. (5) Roll the floating cable and place it on
the cleaner unit. Caution: Do not roll the floating cable on the handle
of the cleaner unit. (6) Store the robotic cleaner components in a dry,
closed location. (7) Verify that the power supply is not exposed to water.
Checking water outlet propeller
It is recommended to periodically clean debris and hair from the
propeller of the water outlet: (1) Unscrew the outlet locker that secures
the outlet cover. (2) Remove the water outlet cover (3) Clean any hairs,
dirt, or debris. (4) Return the outlet locker resecuring the outlet cover.
6
RC60 ROBOTIC POOL CLEANER