Diamond E77/4PF7-N Manual De Instrucciones página 19

WARNINGS
Before switching on the oven, make sure there are no plastic bags, paper, cardboard etc. inside the oven.
5.3.2 USING THE OVEN
- Turn the knob (Fig. 2) clockwise and set the desired temperature. The green light indicates the oven is on.
The orange light indicates thermostat activation: when on, it signals the oven needs heat; when off, it signals the oven has
reached the desired temperature.
- When the orange light goes off, you may introduce the food.
During this stage, you need to fully close the oven door.
At the end of cooking, switch off the oven by turning the knob with the "0" to the index - indicator.
N.B.: A differential cooking is also possible, by concentrating heat either in the upper part or in the lower part.
Turn the knob to the right and set it on the (
300 ° C, the upper and lower resistances are turned on.
When you set the knob on the (
temperature of 270°C.
GRILL USE
Turn the knob clockwise and bring it to the symbol (
The 2750W grill heating element becomes red hot, the yellow and green lamps come on.
During Grill operation, the oven door must stay open.
The grill can also be used to prepare au gratin dishes.
To switch off the grill, turn the know anticlockwise and bring the (
6.
- Clean the stainless steel parts daily with soapy lukewarm water, then rinse well and dry throughly.
- Absolutely avoid to clean the stainless steel with common steel-wool, or common steel brushes and scrapers, as they may
discard ferrous particles which, on depositing, cause rust spots. You may, if you like, use stainless steel-wool passed on
following the butter-finish direction.
- Should the unit remain unused for long periods, heavily rub all the steel surfaces with a cloth slightly wetted with vaseline
oil, in order to cover them with a protective film. Periodically ventilate the premises.
COOKTOP - ELECTRIC COOKING PLATES
We recommend to keep the cooking plates always clean and dry, removing any grease and incrustations through the use also
of appropriate detergent.
To protect them lastingly, we suggest to wipe them with a moist cloth after cleaning, then dry them (possibly by switching
them on) and cover them with a thin film of vaseline oil.
STAINLESS STEEL PARTS
The stainless steel parts must be cleaned with soapy water and then dried with a soft cloth. The bright polish is kept by
periodical wiping with liquid (POLISH), a product easily available.
) symbol. The upper resistance of 1200 W power is turned on; by setting it on
) symbol, both resistances are turned on with thermostatic control up to a maximum
).
- 19 -
) to the index - indicator.
MAINTENANCE AND CLEANING