PURLINE VENTY METABLAST Manual De Instrucciones página 12

EN
PARTS
1. FRONT GUARD
2. BLADES
3. REAR GUARD
4. MOTOR
5. SPEED ADJUSTMENT KNOB
OSCILLATING CONTROL SCREW
6.
7. SET SCREW
SUPPORTER
8.
9. BEND TUBE
10. WALL MOUNT BASE
ASSEMBLY INSTRUCTIONS
CAUTION:
y Before operation ensure set screw holding blades has been tightened by using the Allen
key supplied.
y The spacing between field-wiring control switch of opposite polarity and between a
wiring terminal shall not be less than 3mm.
1. Install the wall mount base on the strong wall.
2. Insert the bend tube into the wall mount base, screw it tightly.
12