PURLINE VENTY METABLAST Manual De Instrucciones página 13

3. Fit the motor unit into the upper part of bend tube and fasten it with set screws.
NOTE:
DO NOT install the fan head to the bend tube before installing the bend tube into
the wall mount base. It may possibly get the link to be anamorphic.
NOTE:
It will mangle the oscillation configuration if dismantle locating screw.
4. Unscrew the 4 pieces of screws which are fixed on the motor front cover. Fit the rear guard
onto motor and secure it with the screws. Please ensure these screws are properly tightened
to avoid vibration noise.
5. Fit blades to motor shaft and lock blades set screw. Fit front guard to rear guard using
clips, screw and nut.
NOTE:
When secure cord anchorage, please ensure sufficient cord loop between motor
and cord anchorage is maintained. Insufficient loop may cause cord shorts out
when fan oscillates.
OPERATION
The voltage of the power source must comply with the details on the type plate of the appliance.
y Plug fan into the power outlet.
y Turn Speed Adjustment Knob to the desired rotating speed:
y Activate oscillation by screwing the Oscillating Control Screw to the outside hole.
NOTE:
ALWAYS SWITCH OFF THE FAN WHEN USING THIS FUNCTION.
y Remove plug from the power outlet after use.
1. Stop/OFF
2. Low Speed
3. Medium Speed
4. High Speed
EN
13