HiTRAx WIN Instrucciones Para El Manejo página 19

Remark: Using (© or (D) to increment or decrement the setting
value hold © or (D 2s to auto increment or decrement the
setting value,
Choose the memory sequence one by one by pressing (A) .
Under MR1 press button (D) to turn on/off syn. and 'SC' will
be appeared on display. This means user can start this function
with chronograph mode.
m: PR%
no nn"
| UU ULI LILI
E mn Gat UFP
- Press and hold button (A) for 2 seconds. The pacer rate will
be flashing.
- Press button (C) for increment the value.
- Press button (D) for decrement the value.
- Then press button (B) to select the figure to adjust ( Pacer,
Second, Minute, Hour, Off/On, MR1 - MR9 )
- Adjust the figure value up or down by button © or D).
- The memories can be turned on or off individual.
- If the pacer memory is syn. with chronograph the set and
turned on memory will start beep sound and count the
preset time to zero then next memory beep rate and timing
will be following until all turned on memories were counted
18
MR1 Pacer 30 bpm for 30° (ON).
MR2 Pacer 60 bpm for 40° (ON).
MR3 Pacer 90 bpm for 15° (ON).
MR4 Pacer 45 bpm for 10° (OFF).
MR5 Pacer 80 bmp for 10° (ON).
MR6 Pacer 30 bmp for 00° (OFF).
MR7 Pacer 60 bmp for 10° (ON).
MR8 Pacer 40 bmp for 20° (ON).
MR9 Pacer 240 bmp for 50° (OFF).
If user turn on the function syn. with chronograph by press
button (D) on MRI, then user select to chronograph mode
and press start. At the same time pacer memory will start
beep rate and count the time according to MR1 to MR. If
the memory turned off. It will auto jump to the next when
the last one count to zero. Until all turned on memories were
counted.
Pacer Memory Setting Mode, select the memory 9 location,
set pulse rate, set time for beep, set the memory function
on/off. Current memory location is activated while all pacer
memory function is disabled ( with '--' ).
mp g Peug |
5353 59
nn
MEMORY | Lt t |