HiTRAx WIN Instrucciones Para El Manejo página 20

In pacer memory mode, when syn. with chronograph is
activated, show the remain time for the pacer memory
sequence.
Default setup for pacer memory value, all memory sequence
is off
m3 PO30
no nn"
| DOLL LILI
| PACER n
EJ UFF
1.9 Speed Mode
This mode shows the lap time or split time against distance.
User can obtain a speed rate in kilometer/ hour or mile/ hour
The setting mode set for a defined distance for each digit
and then the Kilo/ Mile selection.
|
0070 NN ni
SOUL uno
19
- Press and hold button (A) for 2 seconds. Then press button
© or (D) to adjust the figure
- Press button (B) for select each figure & kilometer/ mile.
After finished the distance setting and select kilometer or
mile
User can move to chronograph mode and start chronograph
mode. When the user stop or lap from the chronograph mode.
The record will auto transfer to speed mode and convert into
a speed data
- Press button © or (D) to get the speed data
- Press button (A) to select km or mile/ hour
The speed mode shows the record with the speed calculated
by press button (C) or (D) after the chronograph mode have
lap record and go back to speed mode
id) 123457
e te 3445
K
When the calculated result is overflow, flash the '-Range-'
icon with out of range displayed
TS
(299) BUT oF
PA NUE