Kesser 1220 Instrucciones De Montaje página 12

default setting for the ice cube size is set to "large". If you want to change the size,
press the SELECT button and choose between large ice cubes or small ice cubes. If
the ice cubes are still not the desired size, you can extend the lead time of the
preparation cycle. While the ice preparation is in progress, press and hold the ON/OFF
button for 5 seconds. The number [0] appears at the top of the timer/lead time display
on the display. The number [0] stands for the standard lead time. use the SELECT
button to switch to [1], [2] and back to [0]. If you select [1], the lead time is extended
by 1 minute, if you select [2] by 2 minutes. When you turn the device off and on again,
the default lead time [0] is automatically set again.
14. The production of the ice cubes takes about 6-12 minutes, depending on the selected
size and the ambient temperature.
15. The device monitors the water level during operation. If the water pump stops
pumping water, the device stops automatically and the icon appears on the display
and the arrow icon flashes. In this case, refill water immediately. We recommend that
you first press the ON/OFF button before refilling the water. Then press the ON/OFF
button again to restart the device. If you fill in water without stopping the device, the
ice cube production takes longer. Wait 3 minutes before turning on so that the
coolant can redistribute.
When the device is full of ice cubes
16. When the device is full of ice cubes, the device will automatically stop and the icon
will appear on the display.
How to remove the ice cubes
17. Place the ice cube container on the support cover of the drip tray and press the ICE
button on the control panel. The symbol appears in the display and the ice cube
pressure spring begins to rotate. The ice cubes then gradually fall out of the ice outlet
into the ice cube container. Press the ICE button again, the icon disappears from the
display again and the spring stops turning. No more ice cubes fall from the ice outlet
into the container.
How to tap water
18. The default flow time is 10 seconds. Place a cup under the water outlet and press the
WATER button once. The water flows centrally out of the water outlet, the symbol
appears in the display and the display [10 S] appears in the timer field. After the 10
seconds have elapsed, the symbol goes out and there is no more water coming out
of the outlet. If the flow time is too short or long for you, you can adjust it as you like.
Press and hold the WATER button for at least 5 seconds, the display [10 S] appears in
the timer field. Press the SELECT button to adjust the time of 7-25 seconds. Wait 5
seconds and the reset time will appear in the timer field. The next time you tap water,
the device remembers the newly set time.
How to drain residual water from the device
19. If you want to clean the device or replace the water, you need to drain the residual
water from the tank. To do this, pull the water drain plug from the bottom of the
device and the water will flow out of the device. If your device is equipped with a
hose, connect the hose to the water drain to drain the water comfortably.
20. Change the water in the tank every 24 hours to make sure the water is fresh. If you do
not use the device for a long time, drain the water completely beforehand.
Set timer
• The adjustable time for the timer is 0.5-19.5 hours. The default time is 1 hour.
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
12
www.eshopping.de