Publicidad
Idiomas disponibles
Idiomas disponibles
1. Clean the product with a damp cloth.
2. Dry the product thoroughly with a soft and clean cloth.
3.2 Internal cleaning
• With this function, the motor operates in reverse
direction to draw air from the air outlet
the internal parts of the product with cool air.
• Only use this function periodically. Overuse may
damage the product.
1. Connect the power cord
outlet.
2. Within 10 seconds, press and hold the temperature button
and speed button
activate the internal cleaning mode.
The product operates in reverse direction for about
10 seconds before stopping automatically.
3. If necessary, repeat step 2 to activate this function again.
You can only activate this function 3 times at a time. To enter
the internal cleaning mode again, you must unplug the product
and start over again.
3.3 Cleaning the filter
To avoid the accumulation of dust inside the product, clean the
filter every 2 weeks and replace it every month. New filters can
be purchased on our website (www.silkn.com or www.silkn.ca).
1. Rotate the rear cover
remove the filter
If necessary, insert a small tool between the grilles of the rear
cover and then rotate the rear cover with the tool.
2. Wash the filter with clean water and then air dry it.
The filter must be fully dry. Otherwise, it may damage the
product.
3. Place the filter and rear cover back onto the product.
There are small and large tabs on the rear cover. Make sure
the small tabs are on the top and bottom, and the large tabs
are on the sides when attaching the rear cover (see Fig. C).
4. Rotate the rear cover clockwise until it locks into place.
to an easily accessible power
4
at the same time for about 3 seconds to
5
anticlockwise to detach it and
16
from the product (see Fig. C).
15
EN
and clean
1
6
10
Publicidad
